The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Open end wrench as a caliper.

Thread Modes
Open end wrench as a caliper.
aametalmaster Offline
MTLMSTR
****
Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio
#1
Wink  05-06-2012, 05:13 PM
I have a bunch of 5/8" wide rings to face off and didn't want to read my vernier calipers or even a mic so i grabbed an open ended 5/8" wrench to use as a guage. I know everyone already knew that they could be used as such but there is always one guy who didn't :). Enjoy...Bob


Attached Files Thumbnail(s)
           
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
Open end wrench as a caliper. - by aametalmaster - 05-06-2012, 05:13 PM
RE: Open end wrench as a caliper. - by EdK - 05-06-2012, 05:28 PM
RE: Open end wrench as a caliper. - by DaveH - 05-06-2012, 05:39 PM
RE: Open end wrench as a caliper. - by stevec - 05-06-2012, 06:45 PM
RE: Open end wrench as a caliper. - by mikecwik - 05-06-2012, 09:20 PM
RE: Open end wrench as a caliper. - by EdK - 05-07-2012, 06:15 AM
RE: Open end wrench as a caliper. - by ETC57 - 05-07-2012, 08:53 AM



Users browsing this thread: 1 Guest(s)