07-29-2014, 01:33 PM
I upgraded my press to use the air/hydraulic 20T jack.
The jack is held by a 10mm bolt, the 'top foot' was drilled and taped 10mm.
So you could say it is "hanging by a thread" .................
........I don't know where I find them
'hanging by a thread'
I also made a knob for the release valve - just makes life a little eaier.
DaveH
The jack is held by a 10mm bolt, the 'top foot' was drilled and taped 10mm.
So you could say it is "hanging by a thread" .................
........I don't know where I find them 'hanging by a thread'
I also made a knob for the release valve - just makes life a little eaier.
DaveH