I got an email H&W Machine Repair and Rebuilding in Indiana and they sent me a picture of a BP quill skirt with dimensions:
The dimensions in white are those specified by Kondia). As you can see, the diameter is +.050" compared to the measurements I got from Kondia. Whilst I could trim equal amounts of the ends (if needed to maintain the correct gap), do you think this would cause problems with regards to shifting the tab locations? The tabs are -.013" in width but there is no measurement for their length.
It is probably going to be cheaper for me to get this fabricated locally then buy/ship from the US but since I am in no rush I have the time to contemplate such things!
The dimensions in white are those specified by Kondia). As you can see, the diameter is +.050" compared to the measurements I got from Kondia. Whilst I could trim equal amounts of the ends (if needed to maintain the correct gap), do you think this would cause problems with regards to shifting the tab locations? The tabs are -.013" in width but there is no measurement for their length.
It is probably going to be cheaper for me to get this fabricated locally then buy/ship from the US but since I am in no rush I have the time to contemplate such things!
Hunting American dentists since 2015.