04-18-2014, 04:21 PM
(04-18-2014, 03:10 PM)Shawn Wrote: I know that on my BOB there were only a few inputs available with the jumper configuration I used. Any chance your using an output or don't have the jumpers set correctly? Just tossing ideas out there in case it twigs anything.
Shawn
the only jumper on the breakout board is for pin 17 which will switch it from turning the spindle relay on, or with the jumper off so that pin 17 is for B-dir.
haven't messed with it much today other then to run it a bit when a buddy dropped by for some mud. been out chasing other problems like why a blower I bought new from surplus center won't run no matter how I wire the run cap up to it. Big deal with the blower is I need it to run in a housing so I can get back to melting and casting cast iron before the whole state is under a fire ban.
Guess I could hook up the other breakout board and see what happens. big deal with that is that this board has all the options for spindle control plus the fourth and fifth axis.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!