Converting a X2 clone to CNC

[EdK]

(04-02-2014, 07:45 PM)Shawn Wrote: Thanks Ed, I really appreciate the help. I'm using KL 4030 stepper drivers hooked up to a C10 breakout board. I have found no documentation online explaining how to hook this up but sounds like it would be as simple as wiring to a ground and 5v input and then assigning it in Mach3?

Thanks again Ed
Shawn

You could either use a switch as shown below or if you have an available output you could drive it using your software by hooking up the EN+ to +5V and the EN- to an output from the breakout board.

Ed