|
Tool and Cutter Grinder
|
02-26-2014, 09:55 PM
I think I tried to incorporate some of the features of that one, plus some from other sources. I tried injecting air, but it didn't make the spindle move any easier. I haven't seen any plans for an air spindle.
Mike
If you can't get one, make one. Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Tool and Cutter Grinder - by Hawkeye - 02-26-2014, 12:04 AM
RE: Tool and Cutter Grinder - by stevec - 02-26-2014, 07:00 AM
RE: Tool and Cutter Grinder - by Hawkeye - 02-26-2014, 09:55 PM
RE: Tool and Cutter Grinder - by TomG - 08-10-2014, 01:18 PM
RE: Tool and Cutter Grinder - by stevec - 02-27-2014, 07:15 AM
RE: Tool and Cutter Grinder - by Hawkeye - 03-09-2014, 12:01 AM
RE: Tool and Cutter Grinder - by Old Iron - 03-09-2014, 03:33 AM
RE: Tool and Cutter Grinder - by Hawkeye - 03-09-2014, 10:05 PM
RE: Tool and Cutter Grinder - by stevec - 03-10-2014, 06:13 AM
RE: Tool and Cutter Grinder - by Dr Stan - 08-10-2014, 11:31 AM
RE: Tool and Cutter Grinder - by Hawkeye - 03-10-2014, 08:33 PM
RE: Tool and Cutter Grinder - by RobWilson - 08-10-2014, 01:32 PM
RE: Tool and Cutter Grinder - by TomG - 08-10-2014, 06:12 PM
RE: Tool and Cutter Grinder - by stevec - 08-10-2014, 06:34 PM
RE: Tool and Cutter Grinder - by ieezitin - 08-11-2014, 04:23 PM
RE: Tool and Cutter Grinder - by DaveH - 08-11-2014, 06:30 PM
RE: Tool and Cutter Grinder - by TomG - 08-11-2014, 06:53 PM
RE: Tool and Cutter Grinder - by DaveH - 08-11-2014, 07:02 PM
|
