MetalworkingFun Forum › Machinery › Other Machinery v
Tool and Cutter Grinder

Thread Modes
Tool and Cutter Grinder
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#2
02-26-2014, 07:00 AM
Hawk, Is yours designed after this?


.jpg   endmill grinder.jpg (Size: 6.72 KB / Downloads: 244)

It's the kind I have. Is your R-8 spindle (the one that holds the endmill, or whatever) going to have compressed air to allow it to "float" and move freely?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Tool and Cutter Grinder - by Hawkeye - 02-26-2014, 12:04 AM
RE: Tool and Cutter Grinder - by stevec - 02-26-2014, 07:00 AM
RE: Tool and Cutter Grinder - by Hawkeye - 02-26-2014, 09:55 PM
RE: Tool and Cutter Grinder - by TomG - 08-10-2014, 01:18 PM
RE: Tool and Cutter Grinder - by stevec - 02-27-2014, 07:15 AM
RE: Tool and Cutter Grinder - by Hawkeye - 03-09-2014, 12:01 AM
RE: Tool and Cutter Grinder - by Old Iron - 03-09-2014, 03:33 AM
RE: Tool and Cutter Grinder - by Hawkeye - 03-09-2014, 10:05 PM
RE: Tool and Cutter Grinder - by stevec - 03-10-2014, 06:13 AM
RE: Tool and Cutter Grinder - by Dr Stan - 08-10-2014, 11:31 AM
RE: Tool and Cutter Grinder - by Hawkeye - 03-10-2014, 08:33 PM
RE: Tool and Cutter Grinder - by RobWilson - 08-10-2014, 01:32 PM
RE: Tool and Cutter Grinder - by TomG - 08-10-2014, 06:12 PM
RE: Tool and Cutter Grinder - by stevec - 08-10-2014, 06:34 PM
RE: Tool and Cutter Grinder - by ieezitin - 08-11-2014, 04:23 PM
RE: Tool and Cutter Grinder - by DaveH - 08-11-2014, 06:30 PM
RE: Tool and Cutter Grinder - by TomG - 08-11-2014, 06:53 PM
RE: Tool and Cutter Grinder - by DaveH - 08-11-2014, 07:02 PM



Users browsing this thread: 3 Guest(s)