12-20-2013, 12:50 AM
Shawn, if you get the chance, increase the Y-axis travel. I added almost 2" to mine, but I wish I'd added more.
The X2 mills make great little CNCs. I haven't done a lot on mine, but it's fun to watch it following a program I put together. Sometimes there are
moments, but that's all part of the learning process.
The X2 mills make great little CNCs. I haven't done a lot on mine, but it's fun to watch it following a program I put together. Sometimes there are
moments, but that's all part of the learning process.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.