MetalworkingFun Forum › Machinery › Lathes v
Spindle Crank

Thread Modes
Spindle Crank
Hawkeye Offline
Junior
****
Posts: 535
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
#5
12-17-2013, 12:07 AM
Yeah. It is a bit of a distance. Not quite as easy to reach as on the Hercus. It does have it's uses, though. When I had the chuck off, I used it to check the runout on the inside of the spindle. Pretty hard to turn slowly without the crank.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Spindle Crank - by Hawkeye - 12-15-2013, 12:08 AM
RE: Spindle Crank - by Mayhem - 12-15-2013, 06:35 AM
RE: Spindle Crank - by Hawkeye - 12-16-2013, 12:55 AM
RE: Spindle Crank - by Mayhem - 12-16-2013, 06:27 AM
RE: Spindle Crank - by Hawkeye - 12-17-2013, 12:07 AM



Users browsing this thread: 1 Guest(s)