MetalworkingFun Forum › Machining › General Metalworking Discussion v
Any Logan Shaper advise?

Thread Modes
Any Logan Shaper advise?
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#17
12-07-2013, 07:43 PM
THANKS, will give a 2 inch one a try, didn't have one in stock, the 1 1/2 is slipping when I put a good load on it, the 2 inch will probably make a big difference.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Any Logan Shaper advise? - by sasquatch - 10-18-2012, 08:05 PM
RE: Any Logan Shaper advise? - by f350ca - 10-19-2012, 12:07 AM
RE: Any Logan Shaper advise? - by Sunset Machine - 10-19-2012, 08:17 AM
RE: Any Logan Shaper advise? - by TOM REED - 10-19-2012, 10:34 AM
RE: Any Logan Shaper advise? - by Sunset Machine - 10-20-2012, 08:17 AM
RE: Any Logan Shaper advise? - by f350ca - 10-19-2012, 12:18 PM
RE: Any Logan Shaper advise? - by stevec - 10-19-2012, 03:46 PM
RE: Any Logan Shaper advise? - by sasquatch - 10-19-2012, 05:33 PM
RE: Any Logan Shaper advise? - by sasquatch - 10-19-2012, 05:41 PM
RE: Any Logan Shaper advise? - by f350ca - 10-19-2012, 06:00 PM
RE: Any Logan Shaper advise? - by sasquatch - 10-19-2012, 06:25 PM
RE: Any Logan Shaper advise? - by f350ca - 10-20-2012, 11:45 AM
RE: Any Logan Shaper advise? - by stevec - 10-20-2012, 12:21 PM
RE: Any Logan Shaper advise? - by sasquatch - 10-20-2012, 05:40 PM
RE: Any Logan Shaper advise? - by f350ca - 12-07-2013, 01:55 PM
RE: Any Logan Shaper advise? - by sasquatch - 12-07-2013, 06:02 PM
RE: Any Logan Shaper advise? - by f350ca - 12-07-2013, 07:43 PM



Users browsing this thread: 1 Guest(s)