12-07-2013, 06:02 PM
Greg, Surprised to see this old post. Lol,,, anyway, I did post pics here of my amature restoration in ?? "Other machines" back quite awhile ago.
Hang on,, i'll run and measure that drive pulley,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,, Ok,,, my motor pulley measures 2 inch. That's what was on mine when i found it anyway, and it seems to work fine.
Belt up to the vari-speed, then the drive on the shaper measures 8 inch.
(Found out after mine is a "Porter Cable" pre 1941, before Logan bought the machine division from them. Basicly the same machine from what i can see.
Hang on,, i'll run and measure that drive pulley,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,, Ok,,, my motor pulley measures 2 inch. That's what was on mine when i found it anyway, and it seems to work fine.
Belt up to the vari-speed, then the drive on the shaper measures 8 inch.
(Found out after mine is a "Porter Cable" pre 1941, before Logan bought the machine division from them. Basicly the same machine from what i can see.
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.