11-13-2013, 02:43 PM
Brian, Thanks for the write up.
Did you relocate the cross slide nut to allow increased travel toward the operator? I think what most mini lathe owners have done is to mill out material in the cross slide base. Here are two examples:
http://gadgetbuilder.com/CrossSlide.html
http://mikesworkshop.weebly.com/cross-sl...ravel.html
Can you show us about your half nuts and the new location?
Regards,
Mike
Did you relocate the cross slide nut to allow increased travel toward the operator? I think what most mini lathe owners have done is to mill out material in the cross slide base. Here are two examples:
http://gadgetbuilder.com/CrossSlide.html
http://mikesworkshop.weebly.com/cross-sl...ravel.html
Can you show us about your half nuts and the new location?
Regards,
Mike
MikeK, proud to be a member of MetalworkingFun Forum since Oct 2013.