MetalworkingFun Forum › Machining › General Metalworking Discussion v
its all blown up

Thread Modes
its all blown up
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#14
04-18-2012, 04:37 PM
(04-18-2012, 04:27 PM)doubleboost Wrote: Hi
Bob
I have a decent 240 volt motor under my bench
I am not far away from you (Newcastle) If you need a motor it is there
John

Thats nice of you John SmileSmileSmile

Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
its all blown up - by krv3000 - 04-14-2012, 04:21 PM
RE: its all blown up - by DaveH - 04-14-2012, 06:01 PM
RE: its all blown up - by EdK - 04-14-2012, 07:08 PM
RE: its all blown up - by krv3000 - 04-17-2012, 01:52 AM
RE: its all blown up - by krv3000 - 04-17-2012, 05:15 PM
RE: its all blown up - by Hopefuldave - 04-17-2012, 05:53 PM
RE: its all blown up - by DaveH - 04-17-2012, 05:39 PM
RE: its all blown up - by krv3000 - 04-17-2012, 05:52 PM
RE: its all blown up - by krv3000 - 04-17-2012, 06:05 PM
RE: its all blown up - by krv3000 - 04-18-2012, 09:14 AM
RE: its all blown up - by DaveH - 04-18-2012, 12:03 PM
RE: its all blown up - by EdK - 04-18-2012, 04:01 PM
RE: its all blown up - by doubleboost - 04-18-2012, 04:27 PM
RE: its all blown up - by DaveH - 04-18-2012, 04:37 PM
RE: its all blown up - by krv3000 - 04-19-2012, 01:41 AM
RE: its all blown up - by EdK - 04-19-2012, 04:08 PM
RE: its all blown up - by Hopefuldave - 04-19-2012, 06:07 PM
RE: its all blown up - by krv3000 - 04-19-2012, 06:28 PM
RE: its all blown up - by EdK - 04-19-2012, 06:34 PM



Users browsing this thread: 5 Guest(s)