MetalworkingFun Forum › Machining › General Metalworking Discussion v
Safety First!

Thread Modes
Safety First!
EdK Offline
Whipping Boy
*******
Posts: 8,854
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
#4
09-10-2013, 11:54 AM
(09-10-2013, 09:33 AM)TomG Wrote: ... not all lathes accommodate this technique. ...

Tom

Nor do all body profiles. Smile

I'm too short to use the method you showed in the video so I do what Darren does and stand well to the right side of the spinning work piece.

Ed
Reply
Thanks given by:


Messages In This Thread
Safety First! - by TomG - 09-09-2013, 06:54 PM
RE: Safety First! - by Mayhem - 09-10-2013, 08:20 AM
RE: Safety First! - by TomG - 09-10-2013, 09:33 AM
RE: Safety First! - by EdK - 09-10-2013, 11:54 AM
RE: Safety First! - by DaveH - 09-10-2013, 02:09 PM
RE: Safety First! - by Highpower - 09-10-2013, 03:52 PM
RE: Safety First! - by doubleboost - 09-10-2013, 04:07 PM
RE: Safety First! - by TomG - 09-10-2013, 04:26 PM
RE: Safety First! - by doubleboost - 09-10-2013, 04:33 PM
RE: Safety First! - by TomG - 09-10-2013, 04:44 PM
RE: Safety First! - by Mayhem - 09-10-2013, 05:45 PM
RE: Safety First! - by TomG - 09-10-2013, 06:05 PM
RE: Safety First! - by arvidj - 09-11-2013, 10:00 AM
RE: Safety First! - by TomG - 09-11-2013, 10:07 AM



Users browsing this thread: 2 Guest(s)