09-01-2013, 03:25 PM
It's a no name most likely American made, no fine thread or a stop nut, only got one small die. Only die set I made was a cheap 90* brake from angle iron. Despite being of crude design and low budget it does brake nice radius edges. For 25$ it was cheap, the 3 guys left at this machine shop helped e load it, I bought them lunch and a few beers(cost twice as much as the press)
checking it out on a scrap piece
she's got legs....3 of them
ram and it's gibs
nice threads
the die that came with it.
checking it out on a scrap piece
she's got legs....3 of them
ram and it's gibs
nice threads
the die that came with it.
oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.