09-01-2013, 01:15 PM
Sunset.
The wobble I got is when it first slid into the taper just before applied a slight force to seat it, its hard to explain, it was not as smooth as is should have been, it should have felt like a nice sliding fit, my finish on the bore was quite nice, its a piece of stainless. I will later take pictures.
When I honed in on the finish cut I zipped the speed up a bit and worked the minute spring out of the cutter, I was getting dust in the end. Before I did this I worked spring out, I knew I would get a hair more on the zip cut.
But now like I mentioned in my last post i discovered slight play in the adaptor to the 2JT spigot.
Anthony.
The wobble I got is when it first slid into the taper just before applied a slight force to seat it, its hard to explain, it was not as smooth as is should have been, it should have felt like a nice sliding fit, my finish on the bore was quite nice, its a piece of stainless. I will later take pictures.
When I honed in on the finish cut I zipped the speed up a bit and worked the minute spring out of the cutter, I was getting dust in the end. Before I did this I worked spring out, I knew I would get a hair more on the zip cut.
But now like I mentioned in my last post i discovered slight play in the adaptor to the 2JT spigot.
Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.