08-23-2013, 09:06 AM
ED thats a layout for the segments that I will have to cut and glue together so that I can turn the round part of the pulley were the belt runs
Steve its right at 11 inches I'm going to do that size because thats what the belt fits and like the speed it runs at. I normally run the engine at about half throttle and the trany in 3rd gear, I know its slow but if I put it in backgear and 1st gear you can watch corn grow while it makes a stroke. And I don't have room or shaft length to make a 3 step for the tranny.
OH and don't do the math count the inch marks on the screen print there and Inch apart, you sure its the math and not the homebrew thats making your head hurt.
DA
Steve its right at 11 inches I'm going to do that size because thats what the belt fits and like the speed it runs at. I normally run the engine at about half throttle and the trany in 3rd gear, I know its slow but if I put it in backgear and 1st gear you can watch corn grow while it makes a stroke. And I don't have room or shaft length to make a 3 step for the tranny.
OH and don't do the math count the inch marks on the screen print there and Inch apart, you sure its the math and not the homebrew thats making your head hurt.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!