08-09-2013, 03:11 PM
Funny you should mention the pan... well I made one a week after I had bought it in 1994, just a few days ago took the lathe loose from the wooden bench and put the pan under it, put the ends on last night. Then just a few minutes ago finished wiring it back up along with a light right above it.
Been searching for ideas on storing face plates and chucks, tailstock centers and drill chucks I have a small holder made.
This is going to ruin my standing in the procrastinator's club well if I ever join that is....
Been searching for ideas on storing face plates and chucks, tailstock centers and drill chucks I have a small holder made.
This is going to ruin my standing in the procrastinator's club well if I ever join that is....
oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.