tool holder
#1
Can I or should I use a BXA tool holder for a 10 inch lathe?
toolsinbox, proud to be a member of MetalworkingFun Forum since Aug 2013.
Reply
Thanks given by:
#2
Hi and welcome Thumbsup
See if this helps http://www.metalworkingfun.com/showthread.php?tid=1338
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#3
(08-12-2013, 02:42 AM)DaveH Wrote: Hi and welcome Thumbsup
See if this helps http://www.metalworkingfun.com/showthread.php?tid=1338
Smiley-eatdrink004
DaveH

Thanks for the welcome and the link Dave.
I shall read.
toolsinbox, proud to be a member of MetalworkingFun Forum since Aug 2013.
Reply
Thanks given by:
#4
As to "can I", that can only be answered by taking a few measurements of your lathe. Measure from the top of the compound where the QCTP will be mounted to the centerline of the lathe. That's the critical dimension that will tell you whether you can use a BXA. I'm guessing you won't be able to without some modifications to the QCTP holders but the measurement will tell you for sure. Aloris says for a lathe with a 10" swing you should use an AXA QCTP.

Ed
Reply
Thanks given by:
#5
A belated thanks to you Ed. I am waiting for the AXA
toolsinbox, proud to be a member of MetalworkingFun Forum since Aug 2013.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)