08-05-2013, 07:42 AM
I'll try the angle grinder. I don't have any carbide tooling for my mill.
My X2 is currently running a 1.5 hp treadmill motor, R8 spindle.
Carbide router bits was suggested on another forum.
Chuck
My X2 is currently running a 1.5 hp treadmill motor, R8 spindle.
Carbide router bits was suggested on another forum.
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
The difficult takes me a while, the impossible takes a little longer.