08-04-2013, 02:53 PM
like Ed said take a grinder to it if its not to large.
switch to a fly cutter with a HSS bit with very little rake so you have a good stout cutting point low RPM and if you can go completely thru the skin in one pass.
Skins the toughest part but some castings have pretty thick skin, being what it is I'm supprised your bandsaw cut it without wearing the teeth off the blade.
switch to a fly cutter with a HSS bit with very little rake so you have a good stout cutting point low RPM and if you can go completely thru the skin in one pass.
Skins the toughest part but some castings have pretty thick skin, being what it is I'm supprised your bandsaw cut it without wearing the teeth off the blade.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!