MetalworkingFun Forum › Machining › Welding & Casting v
Hi Lo Shifter handle

Thread Modes
Hi Lo Shifter handle
tekfab Offline
Sophmore
***
Posts: 76
Threads: 6
Joined: Apr 2013
Location: Edinburgh,Scotland
#7
07-27-2013, 04:44 PM
(07-27-2013, 03:35 PM)doubleboost Wrote: It is much better than my miserable attempt today YikesYikesYikesYikes
I moulded the pattern for my dividing head 4 times and could not get the pattern out of the sand properly
Started on a much simpler pattern
John

Bound to be a few "bastards" in the next video !
tekfab, proud to be a member of MetalworkingFun Forum since Apr 2013.
Reply
Thanks given by:


Messages In This Thread
Hi Lo Shifter handle - by dallen - 07-27-2013, 11:45 AM
RE: Hi Lo Shifter handle - by EdK - 07-27-2013, 01:06 PM
RE: Hi Lo Shifter handle - by doubleboost - 07-27-2013, 02:39 PM
RE: Hi Lo Shifter handle - by DaveH - 07-27-2013, 03:13 PM
RE: Hi Lo Shifter handle - by dallen - 07-27-2013, 03:27 PM
RE: Hi Lo Shifter handle - by doubleboost - 07-27-2013, 03:35 PM
RE: Hi Lo Shifter handle - by tekfab - 07-27-2013, 04:44 PM
RE: Hi Lo Shifter handle - by EdK - 07-27-2013, 05:11 PM
RE: Hi Lo Shifter handle - by dallen - 07-27-2013, 07:12 PM
RE: Hi Lo Shifter handle - by oldgoaly - 07-27-2013, 07:39 PM
RE: Hi Lo Shifter handle - by dallen - 07-27-2013, 09:08 PM
RE: Hi Lo Shifter handle - by dallen - 07-28-2013, 05:58 PM



Users browsing this thread: 2 Guest(s)