HI rather than just post a pic of one of my holding devises i did a project on it right you will need 1 old drill chuck the sis and type is up to you a threded rod to fit in to the chuck or if the chuck is male a extending rod a old fil handel that will sute the sise of the chuck in this project i made up a handel right are we all in the one that i have made i had part of the shaft that the chuck came from turnd dawn the back of the shaft to 8mm then with a hacsaw i cut gruves in the shaft this will help it to bond with the fil handel if you have a file handel chuck that up and drill a 8.3 mm hole just a bit deper than the lenth of the shaft as i had to mack up a handel i shaped a pece of a old broom handel up and turnd a step for the ferel and drilld it 8.3 mm i had a old drive belt cog that i bord out to fit the handel fit was not that inportont as it will be all glud up with epoxy ritght fill the hole with epoxy and work the shaft in the hole then leev over night for the glue to go off this bit is opshanel but on the one i did i drilld 2.8 then reemd 3mm thruw the coler and shaft and pind all the way thruw thats it job dun rhite pics
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.