It's here!
Here's the old MicroMark 7X16 on the table I built a couple of months ago for the new Lathe.
I did a partial cutout on the bottom of the legs so I could add levelers.
The table was leveled with a carpenters level. I know from setting up the MicroMark that's
the table is high on the left about .004-.007 Which is what I want.
Uncrating the beast
and finally up on the table.
This weekend I'll start bolting down and leveling with the machinist level.
Here's the old MicroMark 7X16 on the table I built a couple of months ago for the new Lathe.
I did a partial cutout on the bottom of the legs so I could add levelers.
The table was leveled with a carpenters level. I know from setting up the MicroMark that's
the table is high on the left about .004-.007 Which is what I want.
Uncrating the beast
and finally up on the table.
This weekend I'll start bolting down and leveling with the machinist level.
If it's crazy but it works, it's not crazy.