06-17-2013, 05:55 AM
Great write up of your procedure Willie.
I'm a little confused about-
If you made a bushing to fit between the spindle bore and test bar, how did you tighten the collet with the collet closer?
Or have I totally misunderstood.
I'm a little confused about-
(06-16-2013, 11:54 PM)Highpower Wrote: I also made a bushing to fit between the back end of the test bar and the spindle bore to keep it centered. Put the bar and spindex back between the centers with the base plate UP.
If you made a bushing to fit between the spindle bore and test bar, how did you tighten the collet with the collet closer?
Or have I totally misunderstood.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.