Question on machine design
#7
Thanks Jerry. Smiley-eatdrink004
That was my first guess, but wasn't sure.

Greg:

If you can get a model number you could take a look at this site to see if you can find any info on it. http://search.ebscohost.com/login.aspx?a...d=s8251094

The password is "Discovery".

Click on the small engine repair section, and then "tractors". It's a long shot, but you might get lucky. Blush
Willie
Reply
Thanks given by:


Messages In This Thread
Question on machine design - by f350ca - 04-06-2012, 09:30 PM
RE: Question on machine design - by ETC57 - 04-06-2012, 09:39 PM
RE: Question on machine design - by Highpower - 04-06-2012, 09:52 PM
RE: Question on machine design - by f350ca - 04-06-2012, 09:56 PM
RE: Question on machine design - by ETC57 - 04-06-2012, 09:59 PM
RE: Question on machine design - by ETC57 - 04-06-2012, 10:05 PM
RE: Question on machine design - by Highpower - 04-06-2012, 10:15 PM
RE: Question on machine design - by f350ca - 04-07-2012, 08:32 AM
RE: Question on machine design - by stevec - 04-07-2012, 10:27 AM
RE: Question on machine design - by Highpower - 04-07-2012, 10:40 AM
RE: Question on machine design - by B34VD - 04-07-2012, 03:49 PM
RE: Question on machine design - by stevec - 04-07-2012, 05:04 PM



Users browsing this thread: 2 Guest(s)