MetalworkingFun Forum › Machining › General Metalworking Discussion v
Question on machine design

Thread Modes
Question on machine design
ETC57 Offline
Junior
****
Posts: 576
Threads: 18
Joined: Feb 2012
Location: Washington State USA
#6
04-06-2012, 10:05 PM
Greg,

If I had to guess, I'd say it had to do with patents.
The diff. is probably some one else s design so Case used rivets to avoid patent problems.

Just a guess.

Jerry. Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
Question on machine design - by f350ca - 04-06-2012, 09:30 PM
RE: Question on machine design - by ETC57 - 04-06-2012, 09:39 PM
RE: Question on machine design - by Highpower - 04-06-2012, 09:52 PM
RE: Question on machine design - by f350ca - 04-06-2012, 09:56 PM
RE: Question on machine design - by ETC57 - 04-06-2012, 09:59 PM
RE: Question on machine design - by ETC57 - 04-06-2012, 10:05 PM
RE: Question on machine design - by Highpower - 04-06-2012, 10:15 PM
RE: Question on machine design - by f350ca - 04-07-2012, 08:32 AM
RE: Question on machine design - by stevec - 04-07-2012, 10:27 AM
RE: Question on machine design - by Highpower - 04-07-2012, 10:40 AM
RE: Question on machine design - by B34VD - 04-07-2012, 03:49 PM
RE: Question on machine design - by stevec - 04-07-2012, 05:04 PM



Users browsing this thread: 3 Guest(s)