MetalworkingFun Forum › Machining › General Metalworking Discussion v
Question on machine design

Thread Modes
Question on machine design
Highpower Offline
JAFO
******
Posts: 4,452
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
#3
04-06-2012, 09:52 PM
Greg,

Do you know what model that Case tractor is? It might help to narrow things down a bit.

And give me a clue guys... (I'm not a tractor man) what is a "crown" exactly? Chin
Willie
Reply
Thanks given by:


Messages In This Thread
Question on machine design - by f350ca - 04-06-2012, 09:30 PM
RE: Question on machine design - by ETC57 - 04-06-2012, 09:39 PM
RE: Question on machine design - by Highpower - 04-06-2012, 09:52 PM
RE: Question on machine design - by f350ca - 04-06-2012, 09:56 PM
RE: Question on machine design - by ETC57 - 04-06-2012, 09:59 PM
RE: Question on machine design - by ETC57 - 04-06-2012, 10:05 PM
RE: Question on machine design - by Highpower - 04-06-2012, 10:15 PM
RE: Question on machine design - by f350ca - 04-07-2012, 08:32 AM
RE: Question on machine design - by stevec - 04-07-2012, 10:27 AM
RE: Question on machine design - by Highpower - 04-07-2012, 10:40 AM
RE: Question on machine design - by B34VD - 04-07-2012, 03:49 PM
RE: Question on machine design - by stevec - 04-07-2012, 05:04 PM



Users browsing this thread: 3 Guest(s)