05-14-2013, 11:55 AM
(05-14-2013, 08:46 AM)Mayhem Wrote: Personally, my approach is to isolate the power to each machine, ensuring that any accessories are powered down as well.
The annoying one is the cordless drill battery that spends a week on charge
Well, I'm half way there Darren. My lathe and mill share a 120V and 240V circuit which get turned off if I'm not using the machines. The power panel is already full so I can't split them up. It's not a problem since I don't use both machines at the same time. I just don't like having power running to the table feed when I'm using the lathe - because I forgot to turn it off.
I'm guilty of the battery charger thing as well.
Willie