|
Making a steel lathe chuck plate.
|
04-01-2012, 04:14 PM
(04-01-2012, 04:03 PM)EdAK Wrote: Bob, HTP i get off ebay http://www.ebay.com/itm/2-10-lb-Rolls-ER...27be5cfd0c ...Bob
Bob Wright
Metal Master Fab Salem Ohio Birthplace of the Silver and Deming drill bit. 5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders... |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Making a steel lathe chuck plate. - by aametalmaster - 04-01-2012, 11:50 AM
RE: Making a steel lathe chuck plate. - by doubleboost - 04-01-2012, 12:12 PM
RE: Making a steel lathe chuck plate. - by Highpower - 04-01-2012, 01:00 PM
RE: Making a steel lathe chuck plate. - by aametalmaster - 04-01-2012, 02:02 PM
RE: Making a steel lathe chuck plate. - by EdK - 04-01-2012, 02:17 PM
RE: Making a steel lathe chuck plate. - by aametalmaster - 04-01-2012, 02:24 PM
RE: Making a steel lathe chuck plate. - by EdK - 04-01-2012, 04:03 PM
RE: Making a steel lathe chuck plate. - by aametalmaster - 04-01-2012, 04:14 PM
RE: Making a steel lathe chuck plate. - by EdK - 04-01-2012, 04:24 PM
RE: Making a steel lathe chuck plate. - by aametalmaster - 04-01-2012, 05:00 PM
RE: Making a steel lathe chuck plate. - by EdK - 04-01-2012, 05:28 PM
RE: Making a steel lathe chuck plate. - by aametalmaster - 04-01-2012, 06:18 PM
|
