03-17-2013, 10:05 AM
Dave, I like the idea of rotating the head, but would end up doing the same thing Steve just suggested on the lathe, where we already have the tailstock to support the bar. Both suggestions necessitate building a boring bar though.
No power feed on the knee Steve, good old armstrong power feed. Don't believe there are any shops left around here that do engine work, and like you said what fun is that, beter I screw it up.
The cylinder section comes off the block (will get a photo)
Oh ya they' rated at 18 hp but continuous duty Dave.
No power feed on the knee Steve, good old armstrong power feed. Don't believe there are any shops left around here that do engine work, and like you said what fun is that, beter I screw it up.
The cylinder section comes off the block (will get a photo)
Oh ya they' rated at 18 hp but continuous duty Dave.
Free advice is worth exactly what you payed for it.
Greg
Greg