Carbide tool grinders.
#15
(02-02-2013, 11:44 AM)Highpower Wrote: Smiley-signs081

Sorry Arvid, my bad. Aluminum Oxide.
I believe Aluminum Oxide would be the description from a reckognized abrasives manufacturer. "white wheel" is more likely the term used by places like Horror Fright, as even they probably don't know what the composition of their product actually is. Rotfl

Arvid, I have a 60 grit Alu Ox wheel and I really appreciate how it works on HSS. So much better than the greyish mystery abrasifs that come with the grinders.
I'm was planning on getting a 100 or 120 grit wheel to use as a "Finishing wheel" but maybe I should go right to 220?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Carbide tool grinders. - by Highpower - 04-11-2012, 12:58 PM
RE: Carbide tool grinders. - by DaveH - 04-11-2012, 01:51 PM
RE: Carbide tool grinders. - by TOM REED - 04-11-2012, 02:47 PM
RE: Carbide tool grinders. - by Highpower - 04-11-2012, 04:15 PM
RE: Carbide tool grinders. - by EdK - 04-11-2012, 05:04 PM
RE: Carbide tool grinders. - by Highpower - 04-11-2012, 08:52 PM
RE: Carbide tool grinders. - by arvidj - 04-11-2012, 09:33 PM
RE: Carbide tool grinders. - by arvidj - 02-01-2013, 11:35 PM
RE: Carbide tool grinders. - by Highpower - 02-02-2013, 12:38 AM
RE: Carbide tool grinders. - by arvidj - 02-02-2013, 11:24 AM
RE: Carbide tool grinders. - by stevec - 02-02-2013, 10:56 AM
RE: Carbide tool grinders. - by Highpower - 02-02-2013, 11:06 AM
RE: Carbide tool grinders. - by Highpower - 02-02-2013, 11:44 AM
RE: Carbide tool grinders. - by arvidj - 02-02-2013, 01:01 PM
RE: Carbide tool grinders. - by Highpower - 02-04-2013, 12:26 PM
RE: Carbide tool grinders. - by stevec - 02-02-2013, 02:12 PM
RE: Carbide tool grinders. - by sasquatch - 02-02-2013, 04:29 PM
RE: Carbide tool grinders. - by EdK - 02-02-2013, 05:54 PM
RE: Carbide tool grinders. - by EdK - 02-04-2013, 12:30 PM
RE: Carbide tool grinders. - by Highpower - 02-04-2013, 01:29 PM
RE: Carbide tool grinders. - by EdK - 02-04-2013, 01:38 PM
RE: Carbide tool grinders. - by Highpower - 02-04-2013, 01:49 PM
RE: Carbide tool grinders. - by f350ca - 02-04-2013, 01:44 PM
RE: Carbide tool grinders. - by Highpower - 02-04-2013, 01:51 PM



Users browsing this thread: 6 Guest(s)