tool gloat with mixed feeling
#5
(01-27-2013, 11:10 PM)mikecwik Wrote: Oh no wait, I wasn't done. Under the endmills was this.............

[Image: DSCN1097_zps7481d875.jpg]

Amy can flow! http://www.youtube.com/watch?v=khCokQt--l4

Mike,
Nice score on all. You have a lot of inserts there. I use 1/16" end mills for corners and do come in handy even for bigger jobs. Rule of thumb for machining is "break all corners" sharp corners are high stress points and should have a radius to prevent cracks and also saves hands from being cut by the sharp edge.
Paul
pjf134, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
tool gloat with mixed feeling - by mikecwik - 01-27-2013, 09:25 PM
RE: tool gloat with mixed feeling - by Highpower - 01-27-2013, 10:15 PM
RE: tool gloat with mixed feeling - by PixMan - 01-27-2013, 10:40 PM
RE: tool gloat with mixed feeling - by mikecwik - 01-27-2013, 11:10 PM
RE: tool gloat with mixed feeling - by pjf134 - 01-28-2013, 12:16 AM
RE: tool gloat with mixed feeling - by mikecwik - 01-28-2013, 05:19 AM
RE: tool gloat with mixed feeling - by pjf134 - 01-28-2013, 04:20 PM
RE: tool gloat with mixed feeling - by sasquatch - 01-28-2013, 05:19 PM
RE: tool gloat with mixed feeling - by mikecwik - 01-29-2013, 05:31 PM
RE: tool gloat with mixed feeling - by pjf134 - 01-29-2013, 11:09 PM
RE: tool gloat with mixed feeling - by PixMan - 01-28-2013, 10:19 PM
RE: tool gloat with mixed feeling - by Mayhem - 01-29-2013, 04:27 AM
RE: tool gloat with mixed feeling - by EdK - 01-29-2013, 07:30 AM
RE: tool gloat with mixed feeling - by Highpower - 01-29-2013, 08:22 AM
RE: tool gloat with mixed feeling - by pjf134 - 01-29-2013, 11:14 PM



Users browsing this thread: 6 Guest(s)