tool gloat with mixed feeling
#4
Oh no wait, I wasn't done. Under the endmills was this.............

[Image: DSCN1097_zps7481d875.jpg]

Amy can flow! http://www.youtube.com/watch?v=khCokQt--l4
mikecwik, proud to be a member of MetalworkingFun Forum since Apr 2012.
Reply
Thanks given by:


Messages In This Thread
tool gloat with mixed feeling - by mikecwik - 01-27-2013, 09:25 PM
RE: tool gloat with mixed feeling - by Highpower - 01-27-2013, 10:15 PM
RE: tool gloat with mixed feeling - by PixMan - 01-27-2013, 10:40 PM
RE: tool gloat with mixed feeling - by mikecwik - 01-27-2013, 11:10 PM
RE: tool gloat with mixed feeling - by pjf134 - 01-28-2013, 12:16 AM
RE: tool gloat with mixed feeling - by mikecwik - 01-28-2013, 05:19 AM
RE: tool gloat with mixed feeling - by pjf134 - 01-28-2013, 04:20 PM
RE: tool gloat with mixed feeling - by sasquatch - 01-28-2013, 05:19 PM
RE: tool gloat with mixed feeling - by mikecwik - 01-29-2013, 05:31 PM
RE: tool gloat with mixed feeling - by pjf134 - 01-29-2013, 11:09 PM
RE: tool gloat with mixed feeling - by PixMan - 01-28-2013, 10:19 PM
RE: tool gloat with mixed feeling - by Mayhem - 01-29-2013, 04:27 AM
RE: tool gloat with mixed feeling - by EdK - 01-29-2013, 07:30 AM
RE: tool gloat with mixed feeling - by Highpower - 01-29-2013, 08:22 AM
RE: tool gloat with mixed feeling - by pjf134 - 01-29-2013, 11:14 PM



Users browsing this thread: 2 Guest(s)