tool gloat with mixed feeling
#3
Good buy, and you'll get lots of use out of them though many will get broken in the first couple of cuts if you're not careful with the smallest ones.

I've grown so accustomed to using solid carbide end mills at high speeds that I think I'd be back to doing that if I had to use any of the HSS ones my dad has kicking around the shop. ;)
Reply
Thanks given by:


Messages In This Thread
tool gloat with mixed feeling - by mikecwik - 01-27-2013, 09:25 PM
RE: tool gloat with mixed feeling - by Highpower - 01-27-2013, 10:15 PM
RE: tool gloat with mixed feeling - by PixMan - 01-27-2013, 10:40 PM
RE: tool gloat with mixed feeling - by mikecwik - 01-27-2013, 11:10 PM
RE: tool gloat with mixed feeling - by pjf134 - 01-28-2013, 12:16 AM
RE: tool gloat with mixed feeling - by mikecwik - 01-28-2013, 05:19 AM
RE: tool gloat with mixed feeling - by pjf134 - 01-28-2013, 04:20 PM
RE: tool gloat with mixed feeling - by sasquatch - 01-28-2013, 05:19 PM
RE: tool gloat with mixed feeling - by mikecwik - 01-29-2013, 05:31 PM
RE: tool gloat with mixed feeling - by pjf134 - 01-29-2013, 11:09 PM
RE: tool gloat with mixed feeling - by PixMan - 01-28-2013, 10:19 PM
RE: tool gloat with mixed feeling - by Mayhem - 01-29-2013, 04:27 AM
RE: tool gloat with mixed feeling - by EdK - 01-29-2013, 07:30 AM
RE: tool gloat with mixed feeling - by Highpower - 01-29-2013, 08:22 AM
RE: tool gloat with mixed feeling - by pjf134 - 01-29-2013, 11:14 PM



Users browsing this thread: 4 Guest(s)