MetalworkingFun Forum › Machinery › Milling Machines v
First Chips

Thread Modes
First Chips
Bill Gruby
Unregistered
 
#9
12-21-2012, 07:58 AM
Yes the RPM was slow and so was my hand cranking. Did it that way because I ead not completely sure of the mill capability yet. That was a big jump in motor size from 1/2 to 1 HP. Everything is fine now.

"Billy G" Big Grin
Reply
Thanks given by:


Messages In This Thread
First Chips - by Bill Gruby - 12-20-2012, 03:08 PM
RE: First Chips - by PixMan - 12-20-2012, 05:55 PM
RE: First Chips - by stevec - 12-21-2012, 07:43 AM
RE: First Chips - by Mayhem - 12-20-2012, 05:58 PM
RE: First Chips - by Bill Gruby - 12-20-2012, 06:21 PM
RE: First Chips - by DaveH - 12-20-2012, 06:47 PM
RE: First Chips - by sasquatch - 12-20-2012, 07:14 PM
RE: First Chips - by Bill Gruby - 12-20-2012, 08:22 PM
RE: First Chips - by Bill Gruby - 12-21-2012, 07:58 AM
RE: First Chips - by DaveH - 12-21-2012, 12:34 PM
RE: First Chips - by stevec - 12-21-2012, 02:12 PM



Users browsing this thread: 1 Guest(s)