|
First Chips
|
12-21-2012, 07:43 AM
(12-20-2012, 05:55 PM)PixMan Wrote: 390rom for an end mill that size sounds awfully slow, even if it is a HSS tool.Ken, that struck me too! But after trying to calculate the sfm for a 3/16 end mill my head started hurting. Bill, you musta been cranking real slooow for that cut. 
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
First Chips - by Bill Gruby - 12-20-2012, 03:08 PM
RE: First Chips - by PixMan - 12-20-2012, 05:55 PM
RE: First Chips - by stevec - 12-21-2012, 07:43 AM
RE: First Chips - by Mayhem - 12-20-2012, 05:58 PM
RE: First Chips - by Bill Gruby - 12-20-2012, 06:21 PM
RE: First Chips - by DaveH - 12-20-2012, 06:47 PM
RE: First Chips - by sasquatch - 12-20-2012, 07:14 PM
RE: First Chips - by Bill Gruby - 12-20-2012, 08:22 PM
RE: First Chips - by Bill Gruby - 12-21-2012, 07:58 AM
RE: First Chips - by DaveH - 12-21-2012, 12:34 PM
RE: First Chips - by stevec - 12-21-2012, 02:12 PM
|
