MetalworkingFun Forum › Machining › General Metalworking Discussion v
Homemade Penetrating Oil

Thread Modes
Homemade Penetrating Oil
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#12
12-19-2012, 08:25 PM
John - are you talking about heating the nut/bolt with a torch to loosen it or cutting it off with a gas axe Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Homemade Penetrating Oil - by EdK - 12-19-2012, 06:38 AM
RE: Homemade Penetrating Oil - by Mayhem - 12-19-2012, 06:43 AM
RE: Homemade Penetrating Oil - by TomG - 12-19-2012, 07:44 AM
RE: Homemade Penetrating Oil - by EdK - 12-19-2012, 10:16 AM
RE: Homemade Penetrating Oil - by sasquatch - 12-19-2012, 07:56 AM
RE: Homemade Penetrating Oil - by dallen - 12-19-2012, 08:52 AM
RE: Homemade Penetrating Oil - by Sunset Machine - 12-19-2012, 09:01 AM
RE: Homemade Penetrating Oil - by f350ca - 12-19-2012, 10:38 AM
RE: Homemade Penetrating Oil - by dallen - 12-19-2012, 03:00 PM
RE: Homemade Penetrating Oil - by mikecwik - 12-19-2012, 03:42 PM
RE: Homemade Penetrating Oil - by Sunset Machine - 12-20-2012, 09:00 AM
RE: Homemade Penetrating Oil - by the penguin - 12-20-2012, 03:33 PM
RE: Homemade Penetrating Oil - by mikecwik - 12-20-2012, 09:30 PM
RE: Homemade Penetrating Oil - by doubleboost - 12-19-2012, 05:51 PM
RE: Homemade Penetrating Oil - by Mayhem - 12-19-2012, 08:25 PM
RE: Homemade Penetrating Oil - by doubleboost - 12-20-2012, 04:45 AM
RE: Homemade Penetrating Oil - by mikecwik - 12-22-2012, 01:23 AM
RE: Homemade Penetrating Oil - by sasquatch - 12-22-2012, 08:25 AM
RE: Homemade Penetrating Oil - by DaveH - 12-22-2012, 01:12 PM



Users browsing this thread: 4 Guest(s)