Roller v-blocks???

Hello There, Guest! Register

Thread Modes

Roller v-blocks???

Black Forest
Unregistered

#13

12-03-2012, 02:10 PM

Another trial and error method would be to do it in a 3D CAD program. Create different sized discs to be used as a substitute for bearings. Then different sized pipe and then in an assembly you can set it up and use your measuring tool to get the distances. That is how I do it.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Roller v-blocks??? - by Highpower - 12-01-2012, 10:38 PM

RE: Roller v-blocks??? - by stevec - 12-02-2012, 07:54 AM

RE: Roller v-blocks??? - by Highpower - 12-02-2012, 01:35 PM

RE: Roller v-blocks??? - by dallen - 12-02-2012, 08:44 AM

RE: Roller v-blocks??? - by the penguin - 12-02-2012, 09:17 AM

RE: Roller v-blocks??? - by doubleboost - 12-02-2012, 12:53 PM

RE: Roller v-blocks??? - by sasquatch - 12-02-2012, 05:48 PM

RE: Roller v-blocks??? - by stevec - 12-02-2012, 08:00 PM

RE: Roller v-blocks??? - by Highpower - 12-02-2012, 10:11 PM

RE: Roller v-blocks??? - by Mayhem - 12-03-2012, 04:31 AM

RE: Roller v-blocks??? - by Highpower - 12-03-2012, 09:56 AM

RE: Roller v-blocks??? - by Mayhem - 12-03-2012, 10:05 AM

RE: Roller v-blocks??? - by Black Forest - 12-03-2012, 02:10 PM

Users browsing this thread: 1 Guest(s)