|
a bit of center
|
11-11-2012, 08:50 AM
The first boring head I got was for my MT3 spindle on the Mill Drill. That's the same taper as the tailstock of my 12 x 36 lathe so I have no excuse to make a nifty offsetter like Bob's.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
a bit of center - by krv3000 - 11-09-2012, 08:04 PM
RE: a bit of center - by sasquatch - 11-09-2012, 08:22 PM
RE: a bit of center - by Mayhem - 11-09-2012, 09:14 PM
RE: a bit of center - by EdK - 11-10-2012, 08:48 AM
RE: a bit of center - by doubleboost - 11-10-2012, 04:38 AM
RE: a bit of center - by stevec - 11-10-2012, 03:07 PM
RE: a bit of center - by DaveH - 11-10-2012, 04:42 PM
RE: a bit of center - by krv3000 - 11-10-2012, 06:16 PM
RE: a bit of center - by sasquatch - 11-10-2012, 06:27 PM
RE: a bit of center - by DaveH - 11-10-2012, 07:20 PM
RE: a bit of center - by sasquatch - 11-10-2012, 07:44 PM
RE: a bit of center - by DaveH - 11-10-2012, 08:01 PM
RE: a bit of center - by stevec - 11-11-2012, 08:50 AM
|
