MetalworkingFun Forum › Machining › How-To's v
a bit of center

Thread Modes
a bit of center
sasquatch Offline
Senior
*****
Posts: 825
Threads: 25
Joined: Jul 2012
Location: N. Bay Ontario
#9
11-10-2012, 06:27 PM
Somewere back awhile ago on some site there was a project to build one of those tailstock off sets like Bob's, but i can't remember where i saw it!
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:


Messages In This Thread
a bit of center - by krv3000 - 11-09-2012, 08:04 PM
RE: a bit of center - by sasquatch - 11-09-2012, 08:22 PM
RE: a bit of center - by Mayhem - 11-09-2012, 09:14 PM
RE: a bit of center - by EdK - 11-10-2012, 08:48 AM
RE: a bit of center - by doubleboost - 11-10-2012, 04:38 AM
RE: a bit of center - by stevec - 11-10-2012, 03:07 PM
RE: a bit of center - by DaveH - 11-10-2012, 04:42 PM
RE: a bit of center - by krv3000 - 11-10-2012, 06:16 PM
RE: a bit of center - by sasquatch - 11-10-2012, 06:27 PM
RE: a bit of center - by DaveH - 11-10-2012, 07:20 PM
RE: a bit of center - by sasquatch - 11-10-2012, 07:44 PM
RE: a bit of center - by DaveH - 11-10-2012, 08:01 PM
RE: a bit of center - by stevec - 11-11-2012, 08:50 AM



Users browsing this thread: 2 Guest(s)