a bit of center

Thread Modes

a bit of center

stevec Offline

69 yr. old senior

Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada

11-10-2012, 03:07 PM

On the centre offsetting device Bob.
I'm not sure I can relate pics 8 & 9 but I have enough confidence in your work not to question it.
Nice job.

Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.

« Next Oldest | Next Newest »

Messages In This Thread

a bit of center - by krv3000 - 11-09-2012, 08:04 PM

RE: a bit of center - by sasquatch - 11-09-2012, 08:22 PM

RE: a bit of center - by Mayhem - 11-09-2012, 09:14 PM

RE: a bit of center - by EdK - 11-10-2012, 08:48 AM

RE: a bit of center - by stevec - 11-10-2012, 03:07 PM

RE: a bit of center - by DaveH - 11-10-2012, 04:42 PM

RE: a bit of center - by krv3000 - 11-10-2012, 06:16 PM

RE: a bit of center - by sasquatch - 11-10-2012, 06:27 PM

RE: a bit of center - by DaveH - 11-10-2012, 07:20 PM

RE: a bit of center - by sasquatch - 11-10-2012, 07:44 PM

RE: a bit of center - by DaveH - 11-10-2012, 08:01 PM

RE: a bit of center - by stevec - 11-11-2012, 08:50 AM

Users browsing this thread: 2 Guest(s)