Look what showed up today
#7
Don't worry, I will do a build thread in the mill section. Big Grin

I am adding a 2 axis DRO to my mill with the option of replacing the seperate quill DRO with a 3rd scale at a later date. I spent the morning making a new splash shield for the x-axis since I wanted to mount the scale at the back of the table and the supplied shield was much wider than it needed to be. I gained close to an inch of travel so it was worth the effort. The kit I purchased is a little short on the brackets and hardware so it will take a few days to get this completed.

I just had to share a quick pic.

Dan
Collecting tools for 30 years.
Reply
Thanks given by:


Messages In This Thread
Look what showed up today - by DanH - 10-20-2012, 09:43 AM
RE: Look what showed up today - by Highpower - 10-20-2012, 09:50 AM
RE: Look what showed up today - by EdK - 10-20-2012, 10:27 AM
RE: Look what showed up today - by DaveH - 10-20-2012, 12:01 PM
RE: Look what showed up today - by stevec - 10-20-2012, 12:18 PM
RE: Look what showed up today - by krv3000 - 10-20-2012, 02:08 PM
RE: Look what showed up today - by DanH - 10-20-2012, 03:07 PM



Users browsing this thread: 2 Guest(s)