Look what showed up today - Printable Version +- MetalworkingFun Forum (http://www.metalworkingfun.com) +-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html) +--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html) +--- Thread: Look what showed up today (/thread-927.html) |
Look what showed up today - DanH - 10-20-2012 [attachment=3443] RE: Look what showed up today - Highpower - 10-20-2012 SWEET! RE: Look what showed up today - EdK - 10-20-2012 Dan, OK, now you're busted. You know we demand pictures of all projects. Ed RE: Look what showed up today - DaveH - 10-20-2012 Ooow very nice DaveH RE: Look what showed up today - stevec - 10-20-2012 It "showed up"? That sorta peaks the curiosity. I know we always ask for pics but we need words too. RE: Look what showed up today - krv3000 - 10-20-2012 thats wher it got to can i have it back RE: Look what showed up today - DanH - 10-20-2012 Don't worry, I will do a build thread in the mill section. I am adding a 2 axis DRO to my mill with the option of replacing the seperate quill DRO with a 3rd scale at a later date. I spent the morning making a new splash shield for the x-axis since I wanted to mount the scale at the back of the table and the supplied shield was much wider than it needed to be. I gained close to an inch of travel so it was worth the effort. The kit I purchased is a little short on the brackets and hardware so it will take a few days to get this completed. I just had to share a quick pic. Dan |