10-01-2012, 08:13 PM
Looks like a good project Ed.
Not as fancy, used an old keyless chuck off a dead cordless drill, it seems to grab hard enough for the taps that are to small to run in with the mill. Also handy with a chamfering cutter to de burr holes by hand.
![[Image: IMGP1184.jpg]](https://lh6.googleusercontent.com/-hznSnzAfY78/S6EYutWSrZI/AAAAAAAAAGg/xVhvX5-Jt4c/s720/IMGP1184.jpg)
Not as fancy, used an old keyless chuck off a dead cordless drill, it seems to grab hard enough for the taps that are to small to run in with the mill. Also handy with a chamfering cutter to de burr holes by hand.
Free advice is worth exactly what you payed for it.
Greg
Greg