|
Small Tools
|
|
09-30-2012, 04:28 PM
(09-30-2012, 03:55 PM)Arbalest Wrote: Thanks for the comments guys. The tool bit sits in a vee cut into the jig, which is at 30 degrees. If you need more pics let me know. Yes, thanks. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Small Tools - by Arbalest - 09-30-2012, 06:49 AM
RE: Small Tools - by doubleboost - 09-30-2012, 07:09 AM
RE: Small Tools - by Arbalest - 09-30-2012, 07:15 AM
RE: Small Tools - by Wawoodman - 09-30-2012, 07:43 AM
RE: Small Tools - by dallen - 09-30-2012, 07:43 AM
RE: Small Tools - by Arbalest - 09-30-2012, 07:53 AM
RE: Small Tools - by Arbalest - 09-30-2012, 08:12 AM
RE: Small Tools - by sasquatch - 09-30-2012, 08:21 AM
RE: Small Tools - by EdK - 09-30-2012, 09:03 AM
RE: Small Tools - by Arbalest - 09-30-2012, 09:24 AM
RE: Small Tools - by TOM REED - 09-30-2012, 10:52 AM
RE: Small Tools - by DaveH - 09-30-2012, 10:56 AM
RE: Small Tools - by DanH - 09-30-2012, 11:05 AM
RE: Small Tools - by stevec - 09-30-2012, 11:30 AM
RE: Small Tools - by Arbalest - 09-30-2012, 12:19 PM
RE: Small Tools - by TomG - 09-30-2012, 02:21 PM
RE: Small Tools - by Wawoodman - 09-30-2012, 03:07 PM
RE: Small Tools - by Micktoon - 09-30-2012, 03:24 PM
RE: Small Tools - by Arbalest - 09-30-2012, 03:55 PM
RE: Small Tools - by Wawoodman - 09-30-2012, 04:28 PM
RE: Small Tools - by stevec - 09-30-2012, 06:10 PM
RE: Small Tools - by Arbalest - 09-30-2012, 06:29 PM
RE: Small Tools - by monkers - 12-01-2012, 12:34 AM
RE: Small Tools - by stevec - 12-01-2012, 08:23 AM
|
