MetalworkingFun Forum › Machining › Projects v
Small Tools

Thread Modes
Small Tools
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
#5
09-30-2012, 07:43 AM
the tangential bit holder, you make that from a drawing or of your own design? that one is one of the easiest to understand how its made that I've seen.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
Small Tools - by Arbalest - 09-30-2012, 06:49 AM
RE: Small Tools - by doubleboost - 09-30-2012, 07:09 AM
RE: Small Tools - by Arbalest - 09-30-2012, 07:15 AM
RE: Small Tools - by Wawoodman - 09-30-2012, 07:43 AM
RE: Small Tools - by dallen - 09-30-2012, 07:43 AM
RE: Small Tools - by Arbalest - 09-30-2012, 07:53 AM
RE: Small Tools - by Arbalest - 09-30-2012, 08:12 AM
RE: Small Tools - by sasquatch - 09-30-2012, 08:21 AM
RE: Small Tools - by EdK - 09-30-2012, 09:03 AM
RE: Small Tools - by Arbalest - 09-30-2012, 09:24 AM
RE: Small Tools - by TOM REED - 09-30-2012, 10:52 AM
RE: Small Tools - by DaveH - 09-30-2012, 10:56 AM
RE: Small Tools - by DanH - 09-30-2012, 11:05 AM
RE: Small Tools - by stevec - 09-30-2012, 11:30 AM
RE: Small Tools - by Arbalest - 09-30-2012, 12:19 PM
RE: Small Tools - by TomG - 09-30-2012, 02:21 PM
RE: Small Tools - by Wawoodman - 09-30-2012, 03:07 PM
RE: Small Tools - by Micktoon - 09-30-2012, 03:24 PM
RE: Small Tools - by Arbalest - 09-30-2012, 03:55 PM
RE: Small Tools - by Wawoodman - 09-30-2012, 04:28 PM
RE: Small Tools - by stevec - 09-30-2012, 06:10 PM
RE: Small Tools - by Arbalest - 09-30-2012, 06:29 PM
RE: Small Tools - by monkers - 12-01-2012, 12:34 AM
RE: Small Tools - by stevec - 12-01-2012, 08:23 AM



Users browsing this thread: 1 Guest(s)