MetalworkingFun Forum › Machining › General Metalworking Discussion v
Figuring Out The Modulus of a Gear

Thread Modes
Figuring Out The Modulus of a Gear
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#5
09-24-2012, 06:30 PM
(09-24-2012, 06:28 PM)TomG Wrote: Ed,

I believe it's just the pitch diameter of the gear divided by the number of teeth. Chin

Tom

Thanks Tom. That I can work with. I'm sure the lathe change gears are metric but didn't know how to figure out the modulus.

Ed
Reply
Thanks given by:


Messages In This Thread
Figuring Out The Modulus of a Gear - by EdK - 09-24-2012, 06:01 PM
RE: Figuring Out The Modulus of a Gear - by DaveH - 09-24-2012, 06:18 PM
RE: Figuring Out The Modulus of a Gear - by EdK - 09-24-2012, 06:23 PM
RE: Figuring Out The Modulus of a Gear - by TomG - 09-24-2012, 06:28 PM
RE: Figuring Out The Modulus of a Gear - by EdK - 09-24-2012, 06:30 PM



Users browsing this thread: 1 Guest(s)