MetalworkingFun Forum › Machining › General Metalworking Discussion v
Figuring Out The Modulus of a Gear

Thread Modes
Figuring Out The Modulus of a Gear
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#4
09-24-2012, 06:28 PM
Ed,

I believe it's just the pitch diameter of the gear divided by the number of teeth. Chin

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Figuring Out The Modulus of a Gear - by EdK - 09-24-2012, 06:01 PM
RE: Figuring Out The Modulus of a Gear - by DaveH - 09-24-2012, 06:18 PM
RE: Figuring Out The Modulus of a Gear - by EdK - 09-24-2012, 06:23 PM
RE: Figuring Out The Modulus of a Gear - by TomG - 09-24-2012, 06:28 PM
RE: Figuring Out The Modulus of a Gear - by EdK - 09-24-2012, 06:30 PM



Users browsing this thread: 1 Guest(s)