|
Moulding Flasks ,,, Steel
|
09-16-2012, 06:21 AM
Oh yes, What I first wanted to say was, Nice flasks Rob, really nice, really efficient in terms of sand use too, as the corners are rarely used lose them and rather than a batten tacked around the inside to hold sand the bead "wastes" far less sand.
Well done Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Moulding Flasks ,,, Steel - by RobWilson - 02-26-2012, 05:03 AM
RE: Moulding Flasks ,,, Steel - by RobWilson - 02-26-2012, 05:05 AM
RE: Moulding Flasks ,,, Steel - by Mayhem - 02-26-2012, 06:58 AM
RE: Moulding Flasks ,,, Steel - by RobWilson - 02-26-2012, 07:01 AM
RE: Moulding Flasks ,,, Steel - by Mayhem - 02-26-2012, 07:16 AM
RE: Moulding Flasks ,,, Steel - by RobWilson - 02-26-2012, 07:21 AM
RE: Moulding Flasks ,,, Steel - by DaveH - 02-26-2012, 07:39 AM
RE: Moulding Flasks ,,, Steel - by ETC57 - 02-26-2012, 12:27 PM
RE: Moulding Flasks ,,, Steel - by EdK - 02-26-2012, 12:59 PM
RE: Moulding Flasks ,,, Steel - by TOM REED - 02-26-2012, 03:59 PM
RE: Moulding Flasks ,,, Steel - by RobWilson - 02-26-2012, 04:44 PM
RE: Moulding Flasks ,,, Steel - by EdK - 03-02-2012, 08:00 PM
RE: Moulding Flasks ,,, Steel - by stevec - 09-16-2012, 06:45 AM
RE: Moulding Flasks ,,, Steel - by Rickabilly - 09-16-2012, 06:18 AM
RE: Moulding Flasks ,,, Steel - by Rickabilly - 09-16-2012, 06:21 AM
RE: Moulding Flasks ,,, Steel - by Mayhem - 09-16-2012, 07:42 AM
RE: Moulding Flasks ,,, Steel - by stevec - 09-16-2012, 11:31 AM
RE: Moulding Flasks ,,, Steel - by Rickabilly - 09-16-2012, 04:12 PM
|
